powercare@powercapbattery.com

|

+91 95 95 000044

Solar Ultra LED Lamp

Specifications

Power Storage:  3.84 WH
Charging Time of Ultra - Cap From Solar:  2-4 Hrs
Charging Time of Ultra - Cap From Mobile:  1-3 Hrs
Backup Time (Low Mode):  3.5 Hrs
Backup Time (High Mode):  2.15 Hrs
LED Life:  50,000 Hrs ON Time
Solar Panel Type:  Mono/Multi crystalline silicon
Maximum Rated Power - Panel:  10W
Input Voltage for - LED:  3.84 WH
Power Storage:  0.8-2.8V from Ultra-Cap
Efficiency:  >90%
Colour of Light emitted by LED:  Cool White
Weight:  960 gm

Main Features

Lifetime Warranty

Can restart any time after huge gap of usage

Circuit fully protected against high current and over voltage

Energy saving LOW intensity mode is used for studying (No glare).

Pollution Free

Safer than traditional electric current

Solar mobile charger with performance similar to conventional charger with proper protection.

Charging in 60 Minutes for Solar or Mobile charger of 2A in any season (Outdoor as well as Indoor).

Backup Time Low Mode: 3.15 min and High Mode: 2:15 min.

Ergonomic handle with wall mount and table top option.

Assembled in dust free & air conditioned facility.

Light for rural house areas where electricity is not available or limited availability

Installation Instructions

Install Solar panel facing SOUTH direction with 23 (degree) inclination to horizontal-use a study angel frame

Clean the Solar panel regularly with a damp towel to guarantee optimum performance

Do not use any type of solvent for cleaning the Solar panel

Do not put too much pressure while cleaning the Solar panel

Do not allow dust to accumulate on the Solar panel as this would reduce Solar Power transfer

Modes of Operation

Input Modes

Solar Panel Input


  • You can charge the Ultra-Cap by Solar energy by plugging in to the "Solar Panel Input"
  • When the Ultra-Cap is fully charged the "Charger level Indicator" LED turns On

USB Charging Input


  • You can charge the Ultra cap from your mobile phone by plugging in to the "Mobile USB charging Input"
  • If Solar Panel and Mobile Charger both are used for charging - then the Solar Panel will override Mobile Charger
  • While charging the Ultra-Cap through Mobile Charger it is necessary to unplug the Solar Power jack pin

Charging Level Indicator


  • The intensity of the RED LED indicates the level of charge of Ultra-Cap
  • When Ultra-Cap is fully charged LED is turned on at the highest intensity
  • Over-Charging of Ultra-Cap is prevented by technology, so even if RED LED turns ON charging need not be disconnected.

Output Modes

LAMP At High Intensity Mode


  • At HIGH intensity mode 5 out of the 5 LEDs of the lamp are turned on
  • Back up time of the High Mode is 2:15 min.

LAMP At Low Intensity


  • At LOW intensity mode 3 out of the 5 LED's of the lamp are turned on
  • Back up time of LOW Mode is 3.15 min.
  • Energy saving LOW intensity mode is used for studying (No glare).

Mobile Charging


  • You can charge your mobile by plugging it in USB (O/P)
  • USB output will be available only during DAY time i.e. When Solar Power is available

Caution


Do not use any type of solvent for cleaning the Solar panel

Do not put too much pressure while cleaning the Solar panel

Do not allow dust to accumulate on the Solar panel as this would reduce Solar Power transfer

Energy saving LOW intensity mode is used for studying (No glare).

© All rights reserved by Powercap Battery | Proudly Published by Tapsoft